New to 3D Printing and need some help.

[Roxy]

I will have to locate that option, I have found that I cannot use slic3r outside of repg. When I do that and try to use the gcode that slic3r produced it does not work with my machine.

Is this the same for everyone? Also can you point me in a direction to find the bridge speed?

First, in the preferences, turn on Expert mode. File / Preferences / Expert_Mode

Then, in Print_Settings / Speed / Bridges set to 1/5 of your normal speed. And probably you want to set Bridge Acceleration (at the bottom of that same page) pretty low too.

Lastly, and most importantly, in Print_Settings / Advanced / Bridge_Flow_Rate down at 90% or maybe even less.