Results 1 to 4 of 4
Thread: Help with boolean difference
Hybrid View
-
03-24-2023, 07:33 PM #1
- Join Date
- Jun 2014
- Posts
- 885
I selected the Queen component, then performed a plane cut and aligned the cutting plane to the monolith. On execution, I selected both components and performed Combine. The result is attached. There was one flag within Analysis>Inspector but selecting it for repair did not cause any apparent damage. Hope this helps.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion