Colorfabb Plastic filament.

[DrLuigi]

Ive made a simple cube with the XT plastic,
Ive to say it looks great, Also very smooth, Its no where near the quality as your chinese spool,
Also due the filament being perfect on 2.85 i could just put that in slic3r without goofing around if its to much or to less, Its simple spot on.

Its also quiet transparant, i guess this would be great for one of those vase STLs,
I might make one of those later on for you guys to show off how transparant it is when only using 1 wall,
I thought to do that today but i dont have much time left to print ;(.

It seems wood is a bit more tricky tho to get it running decently,
It also seems like it is less strong but its still very nice.


https://www.dropbox.com/s/7i7icseio5...2020.50.12.jpg
The mess is simple because it had a brim, as i didnt know it would warp alot,
So far with the brim it didnt move a bit.
But i am suprised how smooth the sides are, As its 0.2 layerheight and i almost never had that with my normal prints,

Reminder, Not only your Printer has to be reliable, but also your filament so buy one that can be trusted (Example i used to have weird corners when printing a cube, well with Colorfabb its completely gone)
I did go cheap at the beginning but i think i might now always go with Colorfabb, I am suprised in the good way.

I might make over a month or so a new post with every plastic and how it did,
Or i just keep this forum always updated with some logs how my print went.


Edit:
PLA/PHA https://www.dropbox.com/s/jqwo74h09n...2022.18.51.jpg
Again quiet nice as quality goes, except i kinda like the XT series more as quality goes, But the color seems to be lighter than when i had some Chinese one.
Without even using my Caliper i could just let it print at 2.85, after it was printing i checked it for being sure and yet again perfect on it.

Edit:
Another picture of the XT series,

This one is a vase, as i wanted to show how transparant it is.
https://www.dropbox.com/s/yluum2xr2z...531_180833.jpg

Personaly i thought it would be a bit better as transparant goes when only having one wall.