Subscribe to Our Newsletter Advertise
Close



Results 1 to 6 of 6
  1. 01-20-2022, 09:36 AM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,168
    Add Roberts_Clif on Thingiverse

    Hictop controller MPK_V1 pinout mapping

    The pin-out mapping is very similar to the Base v1.3 an MPX.3 they do not have a H6 connector


    You may note : two ICSP ports on controller. H6 is a standard ICSP header, but for programming the ATmega 16U2







    One of my projects is Finished

    MPKv1.jpg
    Last edited by Roberts_Clif; 01-20-2022 at 04:21 PM.
    Reply With Quote Reply With Quote
  2. 01-20-2022, 02:57 PM #2
    curious aardvark
    curious aardvark is offline
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,801
    lol kind of a random post.
    what's the project ?
    Reply With Quote Reply With Quote
  3. 01-20-2022, 03:09 PM #3
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,168
    Add Roberts_Clif on Thingiverse
    Yea kind of.

    Most of the users I have helped with Hictop controllers have asked me many times If I had a Pin-out for the Controller.
    Did not know of a better way of getting this information to them.

    Finally had time so I created a diagram an posted it for all those who asked me for one...
    Reply With Quote Reply With Quote
  4. 01-21-2022, 10:43 AM #4
    curious aardvark
    curious aardvark is offline
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,801
    controller for what ?
    Reply With Quote Reply With Quote
  5. 01-21-2022, 04:56 PM #5
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,168
    Add Roberts_Clif on Thingiverse
    This a Hictop 3D Printer Arduino Mega2560 Ramps compatible single board controller. It is equipped with Dual extruder drivers E0 and E1.
    I find they last a long time it you use TO-220 transistor kits with a bar heat sink.

    Controller 2.jpg

    mounting.jpg
    Reply With Quote Reply With Quote
  6. 01-27-2022, 05:22 PM #6
    curious aardvark
    curious aardvark is offline
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,801
    AHH, cool.Sounds very similar to the boards pruse use for the mk3
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules