Results 1 to 10 of 19
Thread: Printing: Damn corners..
Threaded View
-
10-30-2013, 07:51 AM #14
Well this is going a bit off topic, but i just wanna say that Cura does also shave a few hours at most prints,
At some prints it was like 9 hours with Cura, and with Slicer its like 12-14 hours.
Also with Cura you can just also click at print and it just prints ^^ So easy.
Anyhow,
I also heard nice stuff about Kisslicer but never realy tryed it, Might try that aswell later on ^^
What a diffrence Slicers can't make don't they :P
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion