Results 1 to 10 of 19
Thread: Printing: Damn corners..
Threaded View
-
10-29-2013, 07:51 PM #13
Thanks DrLuigi
Well I told you once slic3r rocks
You can also print .stl files directly, just link your pronterface with slic3r so there will be no need to export G-code with slic3r and then print it with pronterface.
It's not perfect though, as you mentioned it is a bit slow. I remember it froze my mac a few times before I could make G-codes for my yoda bust ... but it was worth it on the end It seems it paid of for you as well
A bit of topic, in Slovene [Kura] means “stupid chick“ and I can't stop laughing every time I hear about this software :PLast edited by Black_sheep; 10-29-2013 at 07:58 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help