Printing: Damn corners..

[DrLuigi]

well i will try this: http://www.thingiverse.com/thing:24238
with 30mm/s :P

argh so slow xD



Edit:

Well Makerfarm made the E axis 841, But this was without a HotEnd (Well also when retracting it was always spot on, when i did a measurement)
But with HotEnd its just not extruding enough.

So know i did it on 926.8 and it seems to be correct again,
Maybe with a all metal extruder there is less friction and it might need to get changed again then,
But ye i aint sure if i should buy one or not ^^

Btw its printing at 40mm/s almost done ^^