Results 1 to 10 of 321
Thread: Flashforge 3D Creator forum.
Threaded View
-
04-09-2014, 11:38 PM #11
No problems Dan,
I thought I'd mention the one big redeeming feature of Makerware that I have come to rely on, and that's the print preview..
Before you print, Tick the "Preview Before Printing" checkbox, under the "Use Defaults" button, bottom left hand corner. This will let you see the layers that will be printed!! when I say it can save you time and pain, I am not overstating ... it seriously is good.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion