Results 1 to 4 of 4
Thread: Odd issue I haven't seen before
Threaded View
-
07-12-2018, 05:30 PM #2
I guess this one has everyone stumped
Not to worry, I've never seen it either. VERY unusual
That some filament would rather cling to the print bed rather than be firmly attached to the rest of the extruded material is quite odd.
If there were contaminants in the filament that might account for it.Last edited by Ward; 07-12-2018 at 05:36 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion