Results 1 to 10 of 11
Thread: BlTouch on Hictop Prusa i3
Threaded View
-
05-28-2018, 12:35 PM #9
- Join Date
- Apr 2018
- Posts
- 6
Sorry for the delay in responding but, had other priorities.
I did all that but, now it seems like the filament will not come out of my new boden extruder.
I found out i had to push the tube all the way into the extruder or else the pla would soften too much.
It's like the pla just wont't go through. If i take a strand of pla and push it through without the boden tube, it does extrude but, not with the boden tube attached and the feed pushing the filament.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion