Results 1 to 10 of 11
Thread: BlTouch on Hictop Prusa i3
Threaded View
-
04-23-2018, 07:45 AM #7
- Join Date
- Apr 2018
- Posts
- 6
I was able to figure out that my offset is .2. The strange thing is that when i do a bed level from my printer's menu, it probes 15 points and then if i do a test print, it scrapes the bed on one side. As if it didn't take into account that the bed was a bit higher on that side. Am i missing a line of code to tell it to adjust with the bed level it just did?
Thanks
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion