BlTouch on Hictop Prusa i3

[Jmarc]

Home the printer... And then lower the nozzle .1mm at a time until the nozzle touches the bed. If your LCD Display says the Z axis is not at 0.000 mm, you need to add the stated Z value to your Z_PROBE_OFFSET value.

I was able to figure out that my offset is .2. The strange thing is that when i do a bed level from my printer's menu, it probes 15 points and then if i do a test print, it scrapes the bed on one side. As if it didn't take into account that the bed was a bit higher on that side. Am i missing a line of code to tell it to adjust with the bed level it just did?

Thanks