Bumps at 90 degree corners, not every layer, looking for opinions

[TTVert]

Yeah I agree on the fitment between two items. I will try slicr and simplify3d and see if the bumps are different. I can't see them being much different really. I've printed a few since then and the lines across the entire layer have been resolved but still have some corners a bit bumpy. I was hoping there was one particular setting I could play with that would help this.
I have increased temp to 205 as I wasn't happy w/ layer adhesion at 196. The temp tower looked best at 196 but it just wasn't as strong as i wanted it to be.

Dave