Results 1 to 10 of 12
Hybrid View
-
07-16-2017, 11:14 AM #1
- Join Date
- May 2017
- Posts
- 10
To continue my monologue:
ZTool:
1.0.6
Fixed issue with empty retraction commands created with newer versions of Z-Suite.
Improved ZCode support for Inventure.
1.0.7
Added option to increase distance between raft and first model layer.
Separate speed setting for 1st model layer.
Fixed: export dialog didn't keep/display setting from previous export.
Fixed: export dialog didn't offer PLA and ASA profiles and therefore changed profile name to ABS.
g2z
1.0.5
Removed the <=10 layers check and improved error/warning messages.
-
02-15-2018, 09:36 PM #2
- Join Date
- Feb 2018
- Posts
- 1
Hello, just wanted to thank you for the z-tool. Z-Suite is ok, but it is really lacking in certain features, and it is nice to have an alternative. I tried and already successfully printed several parts using s3d->z-tool path. I really like that s3d is much better at handling corners. Z-Suite always puts a seam into a corner and those corners are always bulging out. With s3d-Ztool corners are much better. The only parameter I needed to adjust was the retraction, which was set a bit too much at 2mm. I reduced it to 0.5mm.
Is it at all possible to get the source code for the z-tool, or at least data on the zcode? i would like to make some improvements. Yes I can still do it in g-code before sending to ztool, but would be nicer to have fewer steps in the process.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help