Results 1 to 4 of 4
Threaded View
-
03-27-2017, 10:33 AM #3
And if you are prepared to give up after just the one day - perhaps 3d printing, in its current state, is not for you.
I think it took me a couple of weeks before I could get consistent prints when i started.
have you read the manual on printer calibration ?
And are yu trying to print from a memory card or from a usb cable ?Last edited by curious aardvark; 03-30-2017 at 12:44 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help