Results 1 to 10 of 63
Thread: Found at the local junk shop
Threaded View
-
11-20-2016, 10:02 AM #10
found the pictures. no actual shot of the end of the psu - but it is made by: mean well http://www.meanwell.com/
that might help:
pics below.
You can see where we added an on off switch to the front of the printer. But this was before I fitted the print area cooling duct fan.
Once you know the make you can get a model number from a search: Mean Well NES-350-24 power supply. https://www.amazon.com/Mean-NES-350-.../dp/B00KTJE3L4
This is all assuming my clone uses the same board as your original :-)Last edited by curious aardvark; 11-20-2016 at 10:11 AM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion