Results 1 to 10 of 57
Thread: BL Touch and Makerfarm.
Threaded View
-
11-14-2016, 07:57 PM #12
- Join Date
- Jul 2016
- Location
- Pennsylvania, USA
- Posts
- 255
Hi
You may not want to compare to what I have right now. For some strange reason it does not realize the heated bed exists.....I have not quite yet made it to the BL Touch. I suspect I have something *REALY* obvious goofed up. I dropped back to the original firmware and the bed still is ok there. It's not a broken wire somewhere.
Lots of fun !!
====edit
Well, so far: Both RC-Bugfix and RC-7 have the "missing bed heater" issue. Roxy's branch for bed leveling (and the low memory warning ) seems to give me a valid bed temperature. Back to figuring out what's missing where.
BobLast edited by uncle_bob; 11-14-2016 at 08:57 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion