Results 3,671 to 3,680 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
11-02-2016, 11:52 AM #3671
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
11-02-2016, 11:55 AM #3672
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-02-2016, 01:40 PM #3673
Very nice, I've printed 5 or 6 of these items from this remix (http://www.thingiverse.com/thing:937421) and all the ones I printed were at 30% infill. I have heard other users having issues with the jack but I printed the remixed item and didn't run into any problems.
I tested mine with supporting weight and it held up better than I thought (http://www.thingiverse.com/make:225013).
-
11-02-2016, 09:13 PM #3674
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-02-2016, 10:49 PM #3675
-
11-03-2016, 06:19 AM #3676
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-03-2016, 05:21 PM #3677
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Printed a 7" x 3.5" x 2" four sided tray (open top and front) with ~2mm wall thickness in ABS. Large area didn't warp off the bed (yea!), but all of the sides warped and cracked (boo!). Re-printed it in Raptor PLA and it's just perfect. One of these days I'm just gonna stop beating my head against that ABS wall.
-
11-03-2016, 05:43 PM #3678
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-03-2016, 05:44 PM #3679
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Ok, I have a roll of black eSun PETG.
What settings for S3D? If anyone getting good prints can fill me in on settings or upload a FFF profile I can check out that would be great.
OK, back to Ninja!
-
11-03-2016, 08:33 PM #3680
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Hmm, ambient here is~25C-26C and ~42% humidity. I have been running the bed at 95C. After about 20min the interior temp usually can get up to about 32C and the humidity drops to ~30-34%. I've not noticed the temp climbing past ~32C and I am wondering what's different. Why does your setup warm up so? Ideas?
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)