Results 3,661 to 3,670 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
11-01-2016, 06:25 AM #3661
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-01-2016, 06:28 AM #3662
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-01-2016, 07:27 AM #3663
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Have you tried Hatchbox PETG? I see it is a buck cheaper than eSun! I have had pretty good luck with Hatchbox stuff so far. Going to order some PETG to try so was wondering. Looking for a material that has the strength, stiffness and temp handeling abilities of ABS but easier to print.
I have parts that are at the upper range for PLA so ABS is what I go to but don't need full ABS.
-
11-01-2016, 07:32 AM #3664
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Going to try the first full on Ninja-Flex print tonight with the Flexion extrudes. YES - DaveB - all this time and I am finally going to print a flexible filament with the Flexion extruders!!!
Any STL suggestions for a first print? Something straight forward but cool?!!!
-
11-01-2016, 03:19 PM #3665
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
At long last! Congratulations. How about one of these, http://www.thingiverse.com/thing:184890 but make the cam (or the contact part of it) from Ninja-flex?
-
11-01-2016, 10:54 PM #3666
I'd print a Rubber Duck (http://www.thingiverse.com/thing:139894).
-
11-02-2016, 06:16 AM #3667
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-02-2016, 08:40 AM #3668
-
11-02-2016, 08:49 AM #3669
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-02-2016, 11:50 AM #3670
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Just printed this beastie. No assembly required. Very cool to see it unfold from its collapsed form after printing. The high clearance (.65) model printed and worked well for me in MG Maker PLA. The minimal clearance version wouldn't release to open without fracturing. I put infill at 60% due to strength needs of the screw shaft.
http://www.thingiverse.com/thing:925556
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help