Originally Posted by
Talon 3D
Nice!
I am printing with ESun PeTG right now. First print was good except for the screw tab sagged on the SD Card holder model. Now I am working on bed leveling knobs. Been getting about 25% through the print and a glob invariably happens and pulls one or more of the models off the bed. I am going to try and print just one this time.
I did bite the bullet and buy Simplify3D. Liking it so far.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion