Qidi Tech 1 - Replicator 1 clone

[JimHs1]

Here's my ugly ABS calibration cube. The extrusion temp. was 230°C, the bed was 110°C, the feed rate 60, travel feed rate 100. 100% infill, as a calibration cube should be. My guess is that it might be cooling down too fast.

So that's your calibration cube when printing at 100%. How often do you really print at 100% infill? I would think that you would want to calibrate at the way you normally print, i.e., at the infill percent you print at.