Qidi Tech 1 - Replicator 1 clone

[cncartist]

Does anyone know if any of these plastics would hold up to long term submersion in mineral oil?
Gonna fishtank my PC, and try to develop a (somewhat) easy to use kit along the way.

I have no first hand experience with this but I did read that micro-cracks in the surface will allow very thin liquids to seep into the part over time. It can be corrected with proper finishing.

Typical in case humidity during ABS print for me is 36-42%.
I live in south Texas, right on the coast. Can literally walk to gulf of mexico from my house in about 3min.
I have a plan to deal with it, but it's kinda an expensive plan, so its little bit at a time ya.

Gotcha, that is a big difference when yours is doubled at the same temps. I'd be interested to know what you come up with.