Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
03-07-2016, 12:55 PM #11
Ahh, I guess I just skimmed your previous post, didn't notice the T0 vs. T1 difference.
I'm not sure if it is an error. I copied and pasted it from bluemeane's post:
http://3dprintboard.com/showthread.p...ll=1#post81706
The only thing I changed was the "Move to wait position off table" line. The X-130 caused the carriage to hit the left side of the box. Changed it to X-110 and it worked great.
The "Load Right Extruder offsets" line is what I'm using and it is working just fine.
Code:M135 T0 ; Load right extruder offsets
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help