Results 1 to 6 of 6
Threaded View
-
02-26-2016, 03:45 AM #1
- Join Date
- Aug 2015
- Posts
- 21
FFCP: About to install new z axis rod & motor. Installation steps or tips?
It looks like it will be a relatively straight forward procedure honestly. I am having the z axis rod and motor replaced under warranty from flashforge on my creator pro, but I told them I would do the install myself rather than to send it in and wait.
Anyone have install instructions or any general tips from those that have done this before?
I guess what I am asking is that I don't know if I am going to have to re-calibrate the steps per mm for z height in firmware, or if the placement and tension on the installation is so fine tuned that I may cause serious print issues if I don't do the install correctly, or God knows what.
It looks it could a relatively plug and play repair and installation(well kinda), but I could be way wrong.....
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help