It looks like it will be a relatively straight forward procedure honestly. I am having the z axis rod and motor replaced under warranty from flashforge on my creator pro, but I told them I would do the install myself rather than to send it in and wait.

Anyone have install instructions or any general tips from those that have done this before?

I guess what I am asking is that I don't know if I am going to have to re-calibrate the steps per mm for z height in firmware, or if the placement and tension on the installation is so fine tuned that I may cause serious print issues if I don't do the install correctly, or God knows what.

It looks it could a relatively plug and play repair and installation(well kinda), but I could be way wrong.....