Originally Posted by
sniffle
I'll be honest... I could do without the ABL and just have an adjustible offset when homing for Z and i would be gloriously happy... because if the glass is level then abl isnt needed and a number to adjust closeness to the bed makes life so much easier than turning a screw
I don't have ABL, but like you wish I could auto adjust the initial offset. Could you change this line in Marlin to "1"?
Code:
#defineAUTO_BED_LEVELING_GRID_POINTS2
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion