Originally Posted by
tsteever
I am using pins 6, 4 and 2 on the EXP3 port. They are PWM2, Ground, and 5volt respectively.
If you use the firmware I posted and these pins you should be fine as it is working for me. I think i mentioned somewhere that I had intended to use PWM1 but it was later posted that PWM2 can be used. I have that pin defined in my firmware and my abl is working as it should.
I just can't get this thing calibrated to print even close to what I want it to print at. None of the parts are usable as they do not align well at all to the drawings. Everything is slightly too large.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion