Results 1 to 10 of 321
Thread: Flashforge 3D Creator forum.
Threaded View
-
06-05-2014, 10:11 AM #10
- Join Date
- May 2014
- Posts
- 12
Thanks for the response! However, I have encountered a new (unrelated) problem. While printing (most noticeable with smaller pieces/details), plastic seems to 'squish up' or warp in some way (though most commonly vertical) until about half way through the print. This results in very warped bottoms of prints. I have tried increasing the heat of both the platform and the head (+10 degrees) but it hasn't helped much. Any suggestions would be greatly appreciated!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help