Results 1 to 5 of 5
Threaded View
-
07-13-2022, 09:10 PM #1
- Join Date
- Feb 2017
- Posts
- 79
Fan only goes to 50% in code despite setting, feel i'm missing something
I use repetier w/ the cura slicer engine for this. Looking at gcode I'm at 50% fan speed after layer 1 and then it turns off at completion. The slicer is just not going past 50% fan speed for some reasonAccording to my printer settings i see at .50mm i should be at full fan speed. This is the only fan control in entire print at 50% DC.
Code:LAYER:1 M106 S127 G0 F9000 X109.002 Y148.375 Z0.580
And then in my filament setting I can further fine tune this based on layer time, etc (See attached image).
I just do not see any other fan speed settings that would cause this, anyone have any idea where else I can look? I also looked in printer settings but found no mention of anything cooling related.
Thanks
DaveLast edited by TTVert; 07-14-2022 at 09:07 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help