Results 1 to 3 of 3
Threaded View
-
06-05-2017, 11:18 AM #1
- Join Date
- Jan 2016
- Posts
- 4
Best slicer for Qidi Tech (Replicator Dual Clone)?
I am using currently the Makerbot (3.10.0.1364) software as slicer.
On most of my prints there is a problem with the lower 5-6 mm, primarily if there the part has rounded corners.
I print mostly in ABS at 230C extruder and 110C platform temperature with a medium (0.2mm) resolution.
Anything above this problem-zone comes out OK and has the correct dimensions.
Any suggestions are welcome.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion