Results 1 to 8 of 8
Threaded View
-
10-24-2014, 03:44 PM #2
Check out the Flashforge sub-forum on this board: http://3dprintboard.com/forumdisplay...ashForge-Forum
If you want to see some images of prints made on the Flashforge printer: http://3dprintboard.com/showthread.p...rge-3D-printer
I'd personally say that it's a very reliable printer that works well. Makerbot software allows for relatively ease of dual extrusion.
If you have any other questions then ask away, but it's probably a better idea to check the Flashforge sub-forum to get a better idea of the printer
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion