Results 1 to 1 of 1
  1. #1

    I need an opinion on this please

    I can't figure out which setting is causing this distortion on the benchy print. I am using an Ender 3 V2 4.2.2 Cura 5.2.1, eSun PLA+ 205/65 I had a little bit of stringing, could this be a retraction issue or under/over extrusion? Thanks for looking.
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts