~ VSCode squiggles are gonna be the death of me

[Roberts_Clif]

Those line for configuration_adv.h allow you to have another menu location below.

Click > Configuration > Advanced Settings Click
Probe Offset > Click Z Probe Wizard

3D Printer will home
Using Move menu items adjust ti the thickness of a piece of paper of a filler gauge.
Clink on Done
Find Store Settings and save.

start a print, with a couple skirt loops on first layer.
While printing the skirt if it is a little too thick or too thin select menu item babystep Z.

Click Select Tune
Select BabyStep Z adjust until you see that perfect layer
Back out and find Store Settings new Z-Offset is saved

When I first started this menu Item was not available an could take a long long time to adjust Z-Offset.
Later it would take several minutes.

With this LCD control I can set a new Z-Offset is short order.
Once Z-Offset is set you can print over and over again without messing with any settings.
Some times you can go months. Other time it is perfect just with Probe Offset Wizard.

[Roberts_Clif]

Think I see what you did.

Posted Another link

Bruce19.jpg