Results 1 to 1 of 1
Threaded View
-
03-01-2022, 02:06 PM #1
- Join Date
- Jan 2015
- Posts
- 19
X and Y dimensions on prints too short
I have a Makerbot Replicator 2 that has seen 7 years of use. I recently noticed that the x and y dimensions of parts are off by about 1/16th of an inch if it fills the plate. That is a lot. I lowered the nozzle temp to 200 from 210 for tough pla and it had no effect. The Z is accurate. I am using a heated bed which I have at 55. Belts are all tight. Nothing seems loose. Any ideas?
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials