@Curious Aardvark
Ok so its a FlahForge Adventure 3 recently bought. This print was printed on its filament that comes with it.
This is a pic of the of the cylinder. Inside the cylinder on the orange highlighted circle with mouse pointer IS Where the shift happens.
If I hold the printed object in my hand I can clearly see and feel the shift. If I take a photo of it, its not that noticeable unfortunately :*(
Settings that I can see are Layer Height: 0.12mm
Fill Density : 15%
Print Speed: 40mm/s
Shell Count: 3

At the moment the printer settings are at a default setting which just reads "Fine" in FlashForges printer slicer.
Screenshot_20210924_170425.jpg