Results 1 to 10 of 17
Threaded View
-
09-20-2021, 01:23 PM #6
- Join Date
- Feb 2017
- Posts
- 79
I have a ball design in my filament feed that shouldn't allow any binding at all. I did go out there and check but I see no binding. With that said I'd think the higher up it'd print the more binding there would be if there was any. But there are a good 20+ layers up top where it's flawless before getting bad again.Dave
Last edited by TTVert; 09-20-2021 at 01:35 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion