Results 1 to 10 of 255
Threaded View
-
11-18-2014, 08:02 AM #11
I will have to to print this one out once I am printing, thanks AbuMaia!
On another note, since I hot my heat bed heating issues fixed (see the heatbed heating thread), I attempted to print the test cube. I found that the extruder is not feeding into the hotend. I am going to take it apart, but from the looks of this picture, it might just be an alignment issue. As the extrude wanted to push the filiment down, and the retract would pull it out just fine. Any other thoughts? It is hard to tell but could I just tighten the hobbed bolt more to get it to move in further?extruder.jpg
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials