Subscribe to Our Newsletter Advertise
Close



Results 1 to 4 of 4

Threaded View

  1. 07-12-2018, 05:30 PM #2
    Ward
    Ward is offline
    Technologist Ward's Avatar
    Join Date
    Aug 2015
    Posts
    190
    I guess this one has everyone stumped
    Not to worry, I've never seen it either. VERY unusual

    That some filament would rather cling to the print bed rather than be firmly attached to the rest of the extruded material is quite odd.

    If there were contaminants in the filament that might account for it.
    Last edited by Ward; 07-12-2018 at 05:36 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules