BlTouch on Hictop Prusa i3

[Jmarc]

Sorry for the delay in responding but, had other priorities.
I did all that but, now it seems like the filament will not come out of my new boden extruder.
I found out i had to push the tube all the way into the extruder or else the pla would soften too much.
It's like the pla just wont't go through. If i take a strand of pla and push it through without the boden tube, it does extrude but, not with the boden tube attached and the feed pushing the filament.

[Roberts_Clif]

Do not have any experience with bowden extruders, Will have to let someone with bowden extruder experience help you with this one.

Will sit in the background to learn about it though.

[Jmarc]

Do not have any experience with bowden extruders, Will have to let someone with bowden extruder experience help you with this one.

Will sit in the background to learn about it though.

I have no experience, that's why i'm asking for help.

Thanks