Downloaded simplify3d and it really is very nice! I like all of the fine tuning I can do and after the print I am doing is done I'm going to try this puppy out. It has some odd default settings that I'm not sure I want to mess with. It has a relatively slow and small retraction vs. what I am using now, did you guys mess w/ that or leave it? I'll of course know more when I print a test but I'm curious what you guys have done w/ this if anything. Also travel speed (At least I think X/Y axis speed is travel speed) was fairly slow (75mm/s vs. 150mm/s) which I did increase to where I am in cura, ditto the print speed (from 60mm/s to 75mm/s).