Results 1 to 9 of 9
Threaded View
-
07-10-2017, 08:29 PM #3
Okay, I'm up and running. I don't have my FSR Kit installed so I haven't done any auto calibration but even with my manual calibration it's printing quite well. So far no skipping with my 8bit processor, even at 200 segments/mm, so that's pretty rad.
I guess I should also note that I had to make some tweaks in the pins_RAMPS.h file for the viki2 LCD to start working.
Code:#elif ENABLED(VIKI2) || ENABLED(miniVIKI) #define BEEPER_PIN 35 // Pins for DOGM SPI LCD Support #define DOGLCD_A0 47 #define DOGLCD_CS 32 #define LCD_SCREEN_ROT_180 #define BTN_EN1 45 #define BTN_EN2 41 #define BTN_ENC 43 #define SDSS 53 #define SD_DETECT_PIN 49 // Pin 49 for display sd interface, 72 for easy adapter board #define KILL_PIN -1 #define STAT_LED_RED_PIN 39 #define STAT_LED_BLUE_PIN 37
Last edited by LuckyImperial; 07-10-2017 at 11:08 PM.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help