Results 1 to 10 of 18
Thread: One side of my prints are awful
Threaded View
-
06-25-2017, 07:53 PM #4
- Join Date
- Jun 2017
- Posts
- 11
Thank you for the replies!
Marm, sorry, a total rookie mistake on my part. It is PLA 1.75MM
Curious Aardvark, I had read on a FLSun thread somewhere that better print results were achieved when the extruder temp was lowered after the first layer to reduce stringing. (Hasn't helped much) I was attempting to tackle the stringing initially. In my mind, it makes more sense that it would be better if the print were executed at a consistent temp, layers adhering at a consistent rate and all. I'm just getting in from a birthday party but will look at my motors in short order. I'll definitely be looking over your blog as well!
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials