Connections seem to be ok. Swapped connectors just in case. So after stopping the motors, there was a little play on one of the motors, and being Delta it's o that general side. I broke down the top, adjusted my belts, recalibrated my stops, homed, and tested that there was no more play in the mechanism. Sadly the issues persist. I did note that there is more play on the 1 arm on that side, pivotally, than the others, but movement wise in my tests it did not seem to make a noticeable difference. Set the extruder temp to 210 across the board.



20170625_220603.jpg20170625_220610.jpg20170625_220617.jpg

Moving the extruder to the side to see if that helps