Hi all, first post but I have been lurking a while. I finally broke down and got a Creator Pro and all has gone pretty well until recently. My test print was a total success but then I had a few prints where one corner of the raft would lift from the build plate. I re-leveled/trammed the build plate with both the provided card and a standard piece of paper. I also wiped down the 3M blue build plate pad with acetone. This seemed to work fine as the ABS prints all adhered to the build plate and prints came out really nice. Progressively the prints are becoming harder and harder to remove from the build plate to the point where I am destroying prints by removing them from the build plate. So I guess my question is, did I mess up the blue build plate pad by using acetone on it? I think it is similar to buildtak but I know enough to be dangerous!
Thanks