Hotend T0 (T zero) pins not working

[atwooddon]

Looks like the hot end thermistor port on the Ramps 1.4 board has quit. Display says Extruder at 75C when at room temperature or even with the thermistor unplugged. I have a spare thermistor for the hot end and the results are the same using the back up thermistor. So, my question while I order a new board is can I switch the hot end extruder thermistor to use T2 on the board? Need to finish some Xmas printing and it picked a bad time to go funky.... Hopefully it is just a change in the configuration or pins setup but I don't find an obvious place in the files to make a change like that.

Happy Holidays
Don

Update I found the answer. yes you can switch thermistor ports by redefining the pin number in the 'pins.h' file associated with your particular board.