Results 1 to 10 of 57
Thread: BL Touch and Makerfarm.
Threaded View
-
11-15-2016, 06:23 AM #14
- Join Date
- Jul 2016
- Location
- Pennsylvania, USA
- Posts
- 255
Hi
Ok, here's what I did:
Grab RCBugFix, define the display (RepRap Discount Smart Graphical), upload the code to the Ramps.
Reset Ramps
There is no graphic on the display for the heated bed
Try to set bed heat ... no go (from serial, or from sub menus).
Try to run PID tune on the bed ... thermal runaway, glass bed shatters into many pieces. Why did I try that? Terminal stupidity is my only excuse
===
Repeat with everything in sight. I only get a bed heat graphic when the screen reads " UBL6 FT-2020 ready." All the other new branches have the issue with the bed heat on my machine.
I'll pound on it some more this evening. Firmware usually works best after you have a few beers and yell at it a lot ....
Bob
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help