Quote Originally Posted by orm255 View Post
I tried a few more prints and I may have found the culprit.
It may have been retraction vertical lift as after disabling this setting, the print had almost no stringing at all.
I have reduced the temperature to 190°c and this seems to have helped the print.
There are still small pits in the surface of the print and I also suspect that there is some wobble or minor misalignment between the x and y axis (visible on the windows).
http://imgur.com/a/Z8CeJ
Anyone know if I'm right?
If that is the case, does anyone know how this can be fixed/corrected?
The pits look like you;re retracting to much filament. How many mm have you set your extruder to retract at and what speed?

You will always get retraction marks no matter what. Looks like you have your seem position set to Random. Try set it to Aligned or nearest. One or the other tends to chose a corner as the retraction point which makes it less visible and more hidden to a place where people may not look at if its something thats on display.