I have built the Peachy Printer...... not too fiddly.... Well within the capabilities of most people. The little magnets on the armature are probably the hardest part. I used 5 minute epoxy (a tiny amount) to stick those on and seems to be very effective.

However, I connected the peachy to my USB port on a windows machine and booted the software and got the error "An error has occurred - no printer found".
Checked device manager and sure enough Peachy Printer is mapped as a USB device and operating normally. Tried un-installing and re-installing the software, but same result.
Are there some dependencies I am not aware of ???

Tried it on the MAC and got "Please connect your Peachy Printer before starting the software"

So then tried Linux version on UBUNTU.

This said "not complete, more codes be needed" during the build, which failed to complete.

So I need some help !! Can anyone suggest anything I might try? Does anyone have a simple sequential list of instructions for foolproof install on any of those three platforms (including any dependencies). Any help appreciated.