Quote Originally Posted by wirlybird View Post
I have not noticed that but will check next time I change.

I am only using "load" to change filaments and has worked well. Advice I read somewhere on line said to clip the filament and then start the load process and follow the old filament in with the new and run it for a bit until it runs clear. So far it has worked fine.


That's exactly what I recommend and what I've been doing with my Qidi since I got it. Hundreds of filament changes so far and never had an issue, so I'll stick to it. Don't see the point of the unload bit to be honest, this ways just fine.