Solid Layers Rough

[jheikkila54]

Hey Guys,


I have an issue that I cant quite figure out. My solid layers are coming out rough and extruding a bit. I calibrated my e steps and am within 1 mm. I also have "fine tuned" the flow rate using a hollow cube and is within .01 however the solid layers (except for the first layer) look as if I am over extruding or the layers are overlaping to much. I am using a .3 nozzle with .4 layer width and .2 layer height, 2 perimeters, 3 bottom/top layers, printing in ABS at 230. I am using S3D. Any help would be greatly appriciated.